Add: Tel:86-769-22763199  /

COVNA: The first brand solenoid valve electric

We occasionally see relatively large valves in some pipelines and always install bypass valves. Why is this? What is its main function? Under what circumstances does it need to be installed? And what is the size of the bypass valve of the corresponding equipment?


In fact, the bypass valve is installed in the pipeline, and its function can be divided into two major points in general: one is to protect (balance the pressure at both ends), and the other is to make emergency use!

  1. Protection
    It can also be said to be a protective measure for the main valve to prevent the large opening resistance caused by the excessive pressure difference between the front and rear of the valve and the difficult opening of the valve, especially in some large-diameter or high-pressure pipelines. Before the high-pressure pipeline is opened, the pressure is relieved through the bypass valve to avoid sudden influx of high pressure and impact on the pipeline below the valve. Or the pressure difference between the two ends of the valve is too large, and the opening torque is too large. In order to avoid torsion damage to the valve, the valve should be opened after bypassing and releasing the pressure.

 2.the emergency role
When used as a backup pipeline, the biggest advantage is that when the main valve fails or needs maintenance and repair, it can flow through the bypass valve without affecting normal production.

Whether the valve needs to be installed with the specific requirements and settings of the bypass valve: (for reference only)


2.5MPa level, above DN400; 4.0MPa level, above DN250; 6.4MPa level, above DN200; 10MPa level, above DN150


For valves from DN100 to DN200, the bypass pipe and valve are DN20; for valves from DN250 to DN600, the bypass pipe and valve are DN25; for valves above DN600, the bypass pipe and valve are DN40.